![background image](http://html1.mh-extra.com/html/daheng-imaging/mercury2-usb3/mercury2-usb3_user-manual_3255604188.webp)
8.Features
© 2023 China Daheng Group, Inc. Beijing Image Vision Technology Branch 179
8.7.1.
Relevant Parameters
[SequencerMode] Set the parameter to "On", enable the sequencer. Set the parameter to "Off", disable
the sequencer. When enabled, the sequencer controls image acquisitions, switch to next sequence set
after each image is acquired. When disabled, the sequencer is not controlling image acquisitions and
cannot switch parameters.
[SequencerConfigurationMode] Set the parameter to "On", "SequencerSetSave" and "SequencerSetLoad"
are enabled. Set the parameter to "Off", "SequencerSetSave" and "SequencerSetLoad" are disabled and
parameters cannot be saved to the sequence sets.
[SequencerFeatureSelector] Configure the feature that support sequence, like ExposureTime, Gain.
[SequencerFeatureEnabled] Set the parameter to “true”, the feature in "SequencerFeatureSelector" is
supported sequence, currently only true are supported and cannot be changed.
[SequencerSetSelector] Set the sequence set number. The range is determined by the camera model.
[SequencerSetSave] Save parameters to the sequence set in "SequencerSetSelector"
[SequencerSetLoad] Click "SequencerSetLoad", the values of sequence set parameters are overwritten
and replaced by the values stored in the selected sequence set.
[SequencerSetActive] When "SequencerMode" is set to "On", displays the sequence set number currently
in use, as shown below. The advance from one sequence set to the next occurs automatically as
FrameStart trigger signals are received. When "SequencerMode" is set to “Off”, displays "Not Available".
0
1
2
3
0
Image
0
Image
1
Image
2
Image
3
SequencerSetActive
Trigger signals
Images
Figure 8-84 Timing diagram
[SequencerPathSelector] Not currently supported, the set value is fixed to 0.
[SequencerSetNext] The "SequencerSetSelector" sets number to which the next sequence set jumps. For
example, if "SequencerSetSelector" is set to 1 and "SequencerSetNext" is set to 2, then after the camera
uses the parameters to acquire an image, the sequence set will be switched to sequence set 2. Only
sequential jump is supported, "SequencerSetSelector" is set to N, and then "SequencerSetNext" can only
be set to N+1 or 0, and the maximum value of N+1 is "the maximum number of sequence sets supported-
1". If the maximum number of sequences of cameras is 4, the maximum value of N+1 is 3.
[SequencerTriggerSource] The condition for the sequencer to start running, FrameStart only supported.
Each time an image is acquired, the sequence switches to the next sequence set.
8.7.2.
User Guide
Set sequence parameters
1)
Set the "SequencerMode" to "Off" and the "SequencerConfigurationMode" to "On".