Daewoo KBE-6R2SMO, Руководство по обслуживанию

Страница: 12 / 26

11
Control Panel
WARNINg: turn off the electrical power supply to the appliance prior to servicing it. failure to disconnect the power supply
during service may result in an electrical shock or fire hazard.
the control panel, power supply, and relay board assemblies in this oven contain electronic components that are sensitive
to electrostatic discharge (eSD). Wear a properly grounded antistatic wrist strap when handling or servicing the printed
circuit assemblies. Insert the eSD sensitive circuit boards into antistatic bags before placing them on any surface other than
the oven chassis.
Control Panel Removal
• Remove the oven from the wall as specified on page 9.
• Remove the screws from the top of the oven immediately in
back the control panel.
• Grab the sides of control panel with both hands and pull it
forward with a gentle rocking motion until it comes loose
from the front of the oven.
• Disconnect the wires from the back of the control panel
printed circuit board assembly.
• When replacing the control panel, connect the wires from
the oven to the printed circuit board assembly on the back
of the control panel.
Match the location marked to on the connectors to the
locations marked on the printed circuit board.
Oven Controller Removal
(In some models)
• Remove the screws that hold the oven controller in place.
• Remove both of the display flex connectors from the
sockets on the back of the oven controller board.
• Pull the oven controller off the back with a gentle rocking
motion.
• Remove the display from the back of the board.
To reinstall the control panel:
• Reassemble the control panel in the reverse order.
• Install the control panel in its original position and replace screws that hold it in place.
• Reinstall the oven door(s) as described on page 8.
• Test the oven to ensure that repairs were properly completed.
KBE-6R2SSS_6R2SMO(SM)_프랑스향.indd 11 2014-07-18 오후 4:34:30