Daewoo DWD-UD123X, Руководство по обслуживанию

Страница: 38 / 77

36
4) Motor conduction time for a drying cycle
Textile pulling Drying Cooling Wrinkle free Cycle time (min) Heater off/on
Low temperature 10/5 15/5 10/10 10/50 110 70/60
Low temperature (sports shoes) 10/5 2/30 2/30 X 36 70/60
Ironing 10/5 15/5 10/10 10/50 60 105/95
Standard 10/5 15/5 10/10 10/50 150 105/95
Strong 10/5 15/5 10/10 10/50 200 105/95
1
You can select one of 1 hr/ 90 minutes/2 hours.
2
If a sports shoes course is selected and the time is selected, the motor conduction time is determined by a sports
shoes course.
3
Except for a sports shoes course, if the time is selected then the motor conduction time is determined by the
standard course.
5) Drying valve operation
1
20 seconds after drying starts, it continues until drying is completed) 30 sec on/5 sec off.
6) Cooling operation
1
Its purpose is to lower the temperature of the tank after drying is completed) The fan motor and the main motor
operate at the same time.
2
If the drum internal temperature is below 50 degrees, cooling is terminated.
3
The total duration of cooling is five minutes) If the internal temperature can’t be lowered, then the time is not
reduced anymore.
7) Drying heater operation
1
The drying heater continues to operate until drying is completed) 105 deg off/95 deg on.
2
70 deg off/60 deg on for low temperature drying) 50 deg off/40 deg on for a sports shoes course.
3
For air washing, 80 deg off/70 deg on.
8) Wrinkle-free operation
1
It lasts for 30 minutes after drying is completed.
2
During wrinkle-free operation, the motor only operates) The fan motor and the drying v/v do not operate.
3
If you press the pause button during wrinkle-free operation, the motor is stopped and the door is opened.
2-6 Steam operation
1) Steam water supply
1
In steam operation, the water is supplied twice for one minute each.
2
Constant temperature control is done until reaching the initial phase steam water supply point.
3
If the laundry is soaked in the water and the water level drops, then water is supplied again) To reduce the number
of water supplies, the water supply level is set to 10mm higher than the steam point (1.5 phase).
4
Depending on load sensing or the course setting value, the water supply level is chosen to be low or extra low.
5
If powder DET is injected, then the main washing valve is opened and closed five times.
6
If liquid DET is selected the liquid DET stirring motor operates for 30 sec for low levels and for 20 sec for extra
low levels) At this time, the main washing valve operates too.
7
When liquid DET is fully injected, then washing water supply including constant temperature control begins.
8
If powder DET is selected or liquid DET injection completion is memorized, then liquid DET injection process is
skipped.
9
If the water supply is completed, to clean the DET box, the main washing valve and the reserved washing valve
operate for 10 seconds.