Dado Door Master Controller Operation Manual
This document is an overview of the Dado Door System Controller, which
covers all of the programming menu options, including error messages.
1 Introduction to the Dado Door Automation Systems
2
Precautions and Getting started
3 Master Controller Programming LCD and buttons
4 Main Menu Settings
5 System Overview and Features
6 Features cont'd
7 Features cont'd
8 Features cont'd
9
Overload Trip Levels
10 Set Closed Position, Temperature Compensation
11 Set Max Torque, Object Detection Level
12 Accel and Decel Values
13 Set Speeds, Set Arrow Direction Control
14 Open Offset, AutoClose
15 System Input Setup
16 Bootup Routine
17 LED Status Indicators
18 Motor Driver Fault Error Troubleshooting
19 (Advanced) Motor Driver Fault Error Troubleshooting
20 (Advanced) Motor Driver Fault Error Troubleshooting Cont'd
21 Initial Calibration and Setup
22 Initial Calibration and Setup cont'd
23 Error Messages
24 Error Messages cont'd
25 Warning and Precautions
26 RS485 Configuration
27 RS485 Serial Protocol
28 Home Switch Information
29 AUXIO and MISCIO Connections
30 AUXIO and MISCIO Connections cont'd
31 Troubleshooting Section
Note:
From time to time, changes are made to the software and menu
directory. For systems shipped prior to 1/1/13, menu options are different than
shown. Older systems may contain more items than shown above. Effective
1/1/2013, the previously labeled setting " Set I-Max" is now called Max Torque. If
your menu shows I-Max, then the same info contained in this manual regarding
Max Torque will apply to your system. A setting labeled Hand Detect Level on
older versions has been improved and re-labeled as Object Detection Level in
this manual.
