10
Semi-Automatic Coffee System
Setting Up Your Coffee System
Before Your Coffee System is Installed
Call your local water company. Ask them for the water hardness level of the
water supplied to the building where your coffee system will be installed.
If the water hardness level is above four grains per gallon (4gpg):
y
If you are installing model CM24
P
BISAS, contact a water
treatment specialist and have a water treatment system installed to
reduce the water hardness level to 4gpg or less.
y
If you are installing model CM24
T
BISAS, pour only filtered water with a
hardness level of 4gpg or less into the water tank. DO NOT use
distilled water.
Have a licensed electrician install a dedicated, grounded power receptacle
near the coffee system, if one is not available.
Have a qualified installer install the coffee system in the desired location
according to the accompanying installation instructions.
1.
2.
3.
4.
WARNING
To avoid sickness, clean the coffee system completely according
to the
Cleaning and Maintenance
section (including
System
Cleaning
) before operating it for the first time. Doing so will
remove any bacteria left in the unit during shipping and storage.
Make sure the hardness of the water supplied to, or poured into
your coffee system does not exceed the maximum stated below.
Using water harder than that specified will eventually damage the
internal parts and void your warranty.
DO NOT PUSH ANY BUTTONS OR TURN ANY KNOBS ON THE
CONTROL PANEL UNTIL ALL BODY PARTS AND CLOTHING ARE
CLEAR OF THE BREWING COMPARTMENT. KEEP ALL BODY
PARTS AWAY FROM THE BREWING COMPARTMENT DURING OR
IMMEDIATELY AFTER DRINK DISPENSING. HOT LIQUIDS AND
STEAM CAN CAUSE SEVERE BURNS.
•
•
•
