Dacor Built-In Dishwasher, Руководство по обслуживанию

Страница: 15 / 34

Page 3-8
s
eCTion
3 - C
yCle
, s
ysTeMs
& C
oMPonenTs
Checking the Soil Sensor
While in idle mode, simultaneously press and hold Heavy Wash and Start/Cancel buttons.
• This activates the sensor value test.
• If a number does not display, continue with the test.
Disconnect dishwasher from power supply.
Check soil sensor circuit at control.
• A resistance reading should be taken between P2-1 black and P2-7 white at the control for
the emitter.
• A resistance reading should be taken between P2-2 red and P2-7 white at the control for
the detector.
Drain Pump
This dishwasher contains an independent drain pump. It is of a wet rotor design to prevent leaks. The
drain pump is mounted directly to the rear of the sump. The pump cover can be removed for cleaning.
The discharge end of the pump has a check valve to prevent water and odors from entering the
dishwasher from the house drain system. The intake of the pump is connected to the sump by a short
connecting hose. The pump is delivered as a complete assembly.
Checking the Drain Pump
A service test can be performed to test all functions of the dishwasher, including the drain pump.
• The service test is covered in section “Component Function Test”.
IF THE DRAIN PUMP DOES NOT OPERATE
Disconnect dishwasher from power supply.
The location of the drain pump requires that you check the circuit at the control.
• Check between P3-6 brown and P3-8 white.
The resistance should read 26 ohms.
1.
2.
3.
1.
2.
3.
DRAIn PUMP – FIgURE 17
Check Valve Mounting Tab