Dacor Built-In Dishwasher, Руководство по обслуживанию

Страница: 22 / 34

Page 4-5
D
aCor
b
uilT
-i
n
D
ishwasher
s
erviCe
M
anual
Upper Spray Arm Mount
Replacing upper spray arm mount requires removal of cabinet. See section on cabinet removal for
detailed instructions.
Set dishwasher upright and remove upper spray arm. The mount pushes into the top of the tub
with a rubber grommet. An arm on the mount holds it in place to prevent turning during removal/
installation of the upper spray arm.
Reverse procedure for reassembly.
Bottom Door Seal
The bottom door seal is mounted to the bottom of the
inner door panel by five screws. Remove lower rack and
screws to remove seal.
Do not over-tighten screws when reinstalling.
Door Seal
While door is open, remove seal from seal mount on both sides and across top of tub.
To reinstall, begin inserting seal at either the left or right side. Place seal into channel with wide side
towards inside of tub. (See Figure 33)
Run seal up the channel, making sure seal is as deep in channel as possible.
Do not stretch seal around corners, as leakage may occur as a result.
The door seal is precut to the proper length and should not be cut.
Once seal is properly in place, make sure seal is completely in channel. Using a wide blade putty
knife may help to push seal in place.
Close door to make sure door seals. The door catch may need adjusting. See the section on door
latch/switch adjustment page 3-7 for detailed instructions.
1.
2.
3.
1.
2.
1.
2.
3.
4.
5.
6.
7.
FIgURE 32
Bottom Door Seal & Screws
DOOR SEAL – FIgURE 33
Part of seal to inside of tub