![background image](http://html1.mh-extra.com/html/da-lite/tensioned-cosmopolitan-electrol/tensioned-cosmopolitan-electrol_instruction-book_3227320002.webp)
1
IMPORTANT SAFETY INSTRUCTIONS
When using your video equipment, basic safety precautions should always be followed, including the
following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized
service dealer when repair work is required. Incorrect reassembly can cause electric shock when
the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fire, electric shock, or injury to persons.
SAVE THESE INSTRUCTIONS
PRE-INSTALLATION
INSTALLATION
There are three methods of mounting to include:
Flush against wall; Suspended from ceiling (use extension brackets); and Recessed above ceiling.
NOTE:
Under no circumstances should unit be completely sealed in recessed installation. Allow access for service. Picture
surface is centered in case. Case extends 5-1/2" beyond surface on either end. Do not attach anything to screen slat rod
or bottom fabric pocket.
1. Make sure screen is level. Use a carpenter‘s level and plumb level.
CAUTION!
Do not cut wrapping paper or tape with knife or any sharp tool. Remove by hand.
2. Install electrical hook-up that applies to your unit. Make sure to review your Electrical Installation Checklists and
Wiring Diagrams (included) for either 120 Volt Switch, 220/240 Volt Switch, or Low Voltage Control.
3. Test installation by running screen up and down a few times. Be prepared to stop screen. Standard Duty Cycle: 1
MIN. ON / 3 MIN. OFF.
NOTE: Must be installed in accordance with the requirements of the Local Building Codes, the Canadian Electrical Code (CEC), CAN/
CSA C22.1 and the National Electric Code (NEC), NFPA 70.
1. Carefully unpack screen and remove outer wrapping from case.
2. Remove shipping brackets by removing the screws from the slat bar and wooden board.
3. Always handle screen in horizontal position.
PICTURE SURFACE
PICTURE SURFACE
PICTURE SURFACE
CEILING
MOUNTED
WALL MOUNTED
PICTURE SURFACE
CONCEALED (ALLOW ROOM FOR ACCESS)
USE No. 6 BRACKETS
TO HANG BEHIND
BEAM OR VALANCE
Содержание Tensioned Cosmopolitan electrol
Страница 7: ...6 ...