D-Link xStack, Справочное руководство

Страница: 855 / 1284

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
850
Format
config ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | authentication [none | simple <password 8> | md5 <key_id 1-
255>]} (1)
Parameters
<area_id> - Specifies a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
<neighbor_id> - Specifies the OSPF router ID for the remote area. This is a 32-bit number in
the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote area’s Area
Border Router. This is the router ID of the neighbor router.
hello_interval - (Optional) Allows the specification of the interval between the transmission of
OSPF Hello packets, in seconds. The Hello Interval, Dead Interval, Authorization Type, and
Authorization Key should be the same for all routers on the same network.
<sec 1-65535> - Enter the hello packet interval used here. This value must be between 1 and
65535.
dead_interval - (Optional) Allows the specification of the length of time between the receipt of
Hello packets from a neighbor router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead Interval must be evenly
divisable by the Hello Interval.
<sec 1-65535> - Enter the dead packet interval used here. This value must be between 1 and
65535.
authentication - (Optional) Specifies the authentication type used.
none - Specifies that the authentication type will be set to none.
simple - Specifies that a simple text password will be used in the authentication.
<password 8> - Enter the simple text password value here. This value can be up to 8
characters long.
md5 - Specifies that an MD5 key ID will be used for the authentication.
<key_id 1-255> - Enter the MD5 key ID value used here. This value can be between 1 and
255.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the OSPF virtual link:
DGS-3620-28SC:admin# config ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval
10
Command: config ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Success.
DGS-3620-28SC:admin#
73-17 delete ospf virtual_link
Description
This command is used to delete an OSPF virtual link.