D-Link xStack, Справочное руководство

Страница: 1269 / 1284

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1264
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP.
Event description: LCK condition detected
Log Message: LCK condition detected. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>, MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP. Notice
Event description: LCK condition cleared
Log Message: LCK condition cleared. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>, MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP. Notice
DDM Event description: DDM exceeded or recover from DDM alarm
threshold
Log Message: DDM Port <[unitID:]portNum> optic module
[thresholdType] [exceedType] the [thresholdSubType] alarm
threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of
the following values: temperature, supply voltage, bias current, TX
power, RX power.
exceedType: indicate exceed threshold or recover to normal event,
the value should be “recovered from” or “exceeded”
thesholdSubType: the DDM threshold sub type, the value should be
“high” or “low”. Critical
Event description: DDM exceeded or recover from DDM warning
threshold
Log Message: DDM Port <[unitID:]portNum> optic module
[thresholdType] [exceedType] the [thresholdSubType] warning
threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of
the following values: temperature, supply voltage, bias current, TX
power, RX power.
exceedType: indicate exceed threshold or recover to normal event,
the value should be “recovered from” or “exceeded”
thesholdSubType: the DDM threshold sub type, the value should be
“high” or “low”. Warning
BPDU Attack
Protection Event description: BPDU attack happened.
Log Message: Port<[unitID:]portNum> enter BPDU under protection
state (mode: drop / block / shutdown)
Parameters description:
unitID: The unit ID.
portNum: The port number.
mode:The BPDU currnt state Informational