D-Link xStack DES-3800 Series, Руководство пользователя

Страница: 36 / 360

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
7. Under Properties, select VT100 for Emulation mode.
8. Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that you select Terminal keys (not Windows keys).
NOTE: When you use HyperTerminal with the Microsoft® Windows® 2000 operating sys-
tem, ensure that you have Windows 2000 Service Pack 2 or later installed. Windows 2000
Service Pack 2 allows you to use arrow keys in HyperTerminal's VT100 emulation. See
www.microsoft.com for information on Windows 2000 service packs.
9. After you have correctly set up the terminal, plug the power cable into the power receptacle on the back of the Switch.
The boot sequence appears in the terminal.
10. After the boot sequence completes, the console login screen displays.
11. If you have not logged into the command line interface (CLI) program, press the Enter key at the User name and
password prompts. There is no default user name and password for the Switch. The administrator must first create user
names and passwords. If user accounts have been previously set, log in and continue to configure the Switch.
12. Enter the commands to complete your desired tasks. Many commands require administrator-level access privileges. Read
the next section for more information on setting up user accounts. See the xStack DES-3800 Series CLI Manual on the
documentation CD for a list of all commands and additional information on using the CLI.
13. When all tasks have been completed, exit the session with the logout command or close the emulator program.
14. Make sure the terminal or PC you are using to make this connection is configured to match these settings.
If users have problems making this connection on a PC, make sure the emulation is set to VT-100. Set the emulation by clicking
on the
File menu in you HyperTerminal window, clicking on Properties in the drop-down menu, and then clicking the Settings
tab. This is where you will find the Emulation options. If users still do not see anything, try rebooting the Switch by
disconnecting its power supply.
Once connected to the console, the screen below will appear. This is where the user will enter commands to perform all the
available management functions. The Switch will prompt the user to enter a user name and a password. Upon the initial
connection, there is no user name or password and therefore just press enter twice to access the command line interface.
Figure 4- 1. Initial screen after first connection
NOTICE: In case of lost passwords or password corruption, please refer to the
D-Link website and the White Paper entitled “Password Recovery Procedure”,
which will guide you through the steps necessary to resolve this issue.
21