D-Link DXS-1210-10TS, Справочное руководство

Страница: 67 / 394

DXS-1210 Series Smart Managed Switch CLI Reference Guide
64
MINUTES Specifies the timeout length in minutes. 0 represents never timeout.
Default
By default, this value is 3 minutes.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This timer specifies the timeout for auto-logout sessions established by the line that is being
configured.
Example
This example shows how to configure the console session to never timeout.
Switch# configure terminal
Switch(config)# line console
Switch(config-line)# session-timeout 0
Switch(config-line)#
5-17 terminal width
The command is used to set the number of character columns on the terminal screen for the current
session line. The terminal width command will only affect the current session. The terminal width
default command will set the default value, but it doesn’t affect any current sessions.
terminal width NUMBER
no terminal width
Parameters
NUMBER Specifies the number of characters to display on the screen. Valid
values are from 40 to 255.
Default
By default, this value is 80 characters.
Command Mode
Use the EXEC Mode or Privilege EXEC Mode for the terminal width command.
Command Default Level
Level: 1 (for the terminal width command).
Usage Guideline
By default, the Switch’s system terminal provides a screen display width of 80 characters. The
terminal width command changes the terminal width value which applies only to the current session.
When changing the value in a session, the value applies only to that session. When the no form of
this command is used, the number of lines in the terminal display screen is reset to the default, which
is 80 characters.
However, for remote CLI session access such as Telnet, the auto-negotiation terminal width result will
take precedence over the default setting if the negotiation is successful. Otherwise, the default
settings take effect.