Status
D-Link
Unified Wired and Wireless Access System
November 7, 2011
Page 24
D-Link UAP CLI Command Reference
Status
Use the commands in this section to view various AP status information.
Note:
Make sure you are familiar with the names of the interfaces as described in
“Interface Naming
Conventions” on page 20
. The interface name you reference in a get command determines whether
the command output shows a wired or wireless interface, the Internal network, or to radio “one” or
radio two.”
Table 6: Status Commands
Action
Command
Global command to get all details on the Basic Service Set (BSS).
This is a useful command to use to get a comprehensive picture
of how the AP is currently configured.
get bss all detail
Get information about the wired and WLAN interfaces.
get interface
Get the MAC address for the wired internal interface.
get interface wlan0 mac
Get the VLAN ID for the wired interface.
get management vlan-id
Get the network name (SSID) for the default virtual access point.
get interface wlan0 ssid
Get the current IEEE 802.11 radio mode.
get radio wlan0 mode
Get the channel the AP is currently using.
get radio wlan0 channel
Get basic radio settings for the internal interface.
get radio wlan0 [detail]
Get client associations.
get association detail
Get neighboring access points.
get detected-ap detail
Get information about switches that can discover and manage
the AP.
get managed-ap
See the administrative status of the Aeroscout feature.
get aeroscout admin-mode
See the administrative status of the Bonjour protocol.
get bonjour status
See the configured time zone.
get system time-zone