D-Link DGS-510, Справочное руководство

Страница: 14 / 739

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
11
The following example shows how to use the word help to display all the Privileged EXEC Mode
commands that begin with the letters “re”. The letters entered before the question mark (?) are
reprinted on the next command line to allow the user to continue entering the command.
Switch#re?
reset renew rename reboot
Switch#re
The following example shows how to use the command syntax help to display the next argument of
a partially complete telnet command. The characters entered before the question mark (?) is
reprinted on the next command line to allow the user to continue entering the command.
Switch#telnet ?
A.B.C.D IP address of a remote system
WORD Telnet destination hostname
X:X:X:X::X IPv6 address of a remote system
Switch#telnet
2-2 enable
This command is used to enter the Privileged EXEC Mode.
enable [PRIVILEGE-LEVEL]
Parameters
PRIVILEGE-LEVEL (Optional) Specifies to set the privilege level for the user. The
privilege level is between 1 and 15. If
not specified, level 15 will be
used.
Default
None.
Command Mode
User EXEC Mode.
Privilege EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
Execute this command if the current level is lower than the command level. If the privileged level
requires a password, enter it in the field provided. However, only three attempts are allowed. Failure
to access this level returns the user to the current level.
Example
This example shows how to enter the Privileged EXEC Mode.
Switch# enable 15
password:***
Switch#