D-Link DGS-1210 Series, Руководство пользователя

Страница: 44 / 159

4 Configuration
DGS-1210 series Metro Ethernet Managed Switch User Manual
3 3 7 7
System > Web Settings
The WEB State is Enabled by default. If user chooses to disable this by selecting Disabled, user will lose the
ability to configure the system through the web interface as soon as these settings are applied.
Figure 4.39– System > Web Settings
Port (1-65535): Specifies the Port number. The range is between 1 and 65535 with the well-known default is
80.
Click Apply to make the configurations take effect.
System > Telnet Settings
Telnet configuration is Enabled by default. If user does not want to allow the Telnet configuration, they only
need to disable the Telnet State.
Figure 4.40 – System > Telnet Settings
Port (1-65535): The TCP port number. TCP ports are numbered between 1 and 65535. The well-known TCP
port for the Telnet protocol is 23.
Click Apply to make the configurations take effect.
System > Password Encryption
The Password Encryption page is used to enable or disable the password encryption state. Select Enabled
and click Apply to make the configurations take effect.
Figure 4.41 – System > Password Encryption
System > Ping Test
The Ping Test is a small program that sends ICMP Echo packets to the IP address you specify. The
destination node then responds to or “echoes” the packets sent the Switch. This is very useful to verify
connectivity between the Switch and other nodes on the network.
Figure 4.42 – System > Ping Test