D-Link DAS-3636, Справочное руководство CLI

Страница: 291 / 480

DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
31
T
RAFFIC
C
ONTROL
C
OMMANDS
On a computer network, packets such as Multicast packets and Broadcast packets continually flood the network as normal
procedure. At times, this traffic may increase do to a malicious endstation on the network or a malfunctioning device, such as a
faulty network card. Thus, switch throughput problems will arise and consequently affect the overall performance of the switch
network. To help rectify this packet storm, the Switch will monitor and control the situation.
The packet storm is monitored to determine if too many packets are flooding the network, based on the threshold level provided
by the user. Once a packet storm has been detected, the Switch will drop packets coming into the Switch until the storm has
subsided. This method can be utilized by selecting the
Drop option of the Action field in the window below.
The Switch will also scan and monitor packets coming into the Switch by monitoring the Switch’s chip counter. This method is
only viable for Broadcast and Multicast storms because the chip only has counters for these two types of packets. Once a storm
has been detected (that is, once the packet threshold set below has been exceeded), the Switch will shutdown the port to all
incoming traffic with the exception of STP BPDU packets, for a time period specified using the
countdown field. If this field
times out and the packet storm continues, the port will be placed in a Shutdown Forever mode which will produce a warning
message to be sent to the Trap Receiver. Once in Shutdown Forever mode, one method of recovering this port is to manually
recoup it using the
Port Configuration window in the Administration folder and selecting the disabled port and returning it to an
Enabled status. To utilize this method of Storm Control, choose the Shutdown option of the Action field in the window below.
The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config traffic control [<portlist> | all] {broadcast [enable | disable] | multicast [enable | disable] | unicast [enable |
disable] | action [drop | shutdown] | threshold <value 0-255000> | time_interval <value 5-
30> | countdown [value 0 | <value 5-30>]}
show traffic control {<portlist>}
config traffic trap [none | storm_occurred | storm_cleared | both]
Each command is listed, in detail, in the following sections.
286