D.A.S. DXi Series, Руководство пользователя

Страница: 37 / 56

37
Manual del Usuario
/ DXI series /
User’s Manual
REMOTE CONTROL (cont'd)
Mode = Ethernet Only: The Ethernet control port on the rear panel is active. Selecting this choice will
then ask for the following further information to be confirmed:
RS485 Relay: Choose ON to relay all remote control data onto the RS485 network for
connection to further devices (other DAS Audio units)
RS485 Speed: Only shown if RS485 Relay = ON: set RS485 baud rate (recommended to use
57600)
Remote ID Number: Set a device ID (still required even on Ethernet connections). This must
be unique to the connected unit – setting the same ID on multiple units may cause comms
problems for all devices.
IP Mode: Choose either Static or Auto IP. Auto IP will generate an IP address based on
unique hardware features such as MAC address. Choose Static if you need to select the IP
address to lie within a specific range, for instance when working within a larger infrastructure.
GtWay: The gateway address is used for external access to the Internet and should be left at
the default setting.
SubNt: The subnet mask is used to subdivide IP addresses into groups that allow further sub-
groups addressing to be defined, so further extending the address range.
Leave at default 255.255.255.0 unless specifically required.
IP: The IP address specifies the amplifier's unique identifier on the Ethernet network. It is
used in conjunction with the amplifier's Remote ID number to identify individual devices on
the network. Make sure this is not set to the same value as any other devices or comms
problems will occur.