D.A.S. DXi Series, Руководство пользователя

Страница: 14 / 56

14
Manual del Usuario
/ DXI series /
User’s Manual
ANALOGUE IN CALIBRATION
NETWORK
INPUTS ABCD*
A
B
C
D
NEUTRIK
NEUTRIK
NEUTRIK
NEUTRIK
ANALOGUE C OR AES A+B
ANALOGUE D OR AES C+D
OR
OR
2
4
2
SOURCE SWITCH 12-4
*Network audio input and output (Dante)
Source Choices and Selection
Your amplifier can source audio from analogue, AES digital,
or network locations (DANTE).
Analogue and AES digital audio are standard, and arranged
so that AES digital audio can be chosen in pairs of channels to
replace either analogue inputs A&B together or analogue
inputs C&D together, or all four channels.
Physical input of AES for channels A&B is swapped to the
input XLR for channel C and the AES input for channels C&D is
on the XLR socket for channel D.
In this way, a pair of analogue inputs can remain connected
to channels A&B and a digital stream of the same audio can be
connected to input C, with fallback from one to the other
possible without repatching.
With the DANTE card, four additional digital sources will be
available.
In total, 8 sources can be made available at any one time –
four analogue and four digital. This affects the choices that
can be made for routing to the inputs of the DSP channels.
The rules are as follows:
Analogue A and B is available at all times;
If AES A&B is selected, Analogue C cannot be used (shares XLR C);
If AES C&D is selected, Analogue D cannot be used (shares XLR D);
If AES A&B is chosen, Dante A&B cannot be used (shares SRC One);
If AES C&D is chosen, Dante C&D cannot be used (shares SRC Two);
Source selection is therefore affected by the selection of AES inputs, which then controls the choice
of input source selections on offer to any input processing channel.
Please see page 23 for further info on using the AES and Input source selection menu options.
Input Processing Channels
Your amplifier has four input channels
of processing that can be fed from a
variety of sources.
These four channels in turn, feed a
mix matrix for routing to the power
amplifier processing channels and the
auxiliary output processing channels.
Each input processing channel consists of the following sections:
Input gain control
Input delay time
Input parametric EQ bands 1 through 9
The dynamic EQ sections will be added in a future firmware update. For more information on
adjusting input processing parameters, please see the section beginning on page 17.
DSP LAYOUT, CONFIGURATIONS AND ROUTING (cont'd)