D.A.S. DX-100I, Руководство пользователя

Страница: 36 / 56

36
Manual del Usuario
/ DXI series /
User’s Manual
REMOTE CONTROL
Overview
Your amplifier is equipped with multiple options for remote control. It can operate as a single device
via a USB connection to the front panel, and this can also be used as a converter to an RS485 network,
where other DX series amplifiers or DAS system units may be connected.
It may also be controlled via an Ethernet connection and again will relay data onto an RS485 network
if required.
The Ethernet and USB connections can be used in an intelligent switchover mode, where the
Ethernet connection is active, but will be overridden by a USB connection, allowing quick connection to
a system via the front panel without needing to reconfigure the current remote interface setup.
The RS485 network can be used on its own as third means of communication, if the amplifier is part
of a bigger system and an Ethernet connection is not available.
Using an Ethernet connection, multiple amplifiers can be connected directly to a standard Ethernet
switch, or WiFi router, allowing for wireless communication.
Finally, the GPIO port on your amplifier can be configured to feed back a variety of alarm signals
(such as over temperature threshold, or protection triggered) and offer simple closed contact control of
standby mode, mutes or memory recalls. It also accepts variable voltages which allow direct level
control of selected channels' gains.
Remote Control Software Choices
Your amplifier is designed to be fully configured via AudioCore.
Main configuration is performed via AudioCore, either with a wired connection via Ethernet, USB or
RS485. Connection to amplifiers is also possible wirelessly using the Ethernet connection if this is via a
wireless router.
Tuning of a system can then be performed wirelessly (via a WiFi connection) using just the iPad or
tablet.
Configuration of the Remote Interface
To configure the remote interface, from the home screen, press MENU, choose the INTERFACE Sub-
Menu and press ENTER.
Use the encoder or BACK and NEXT keys to select External Interface and press ENTER.
Use the encoder or BACK and NEXT keys to choose the required interface and press ENTER. This
will invoke a series of further options depending on the interface chosen – these are explained below:
Mode = OFF: Interface is disabled and no external comms are active. This is useful if you need to
fully secure your amplifier as well as locking the front panel (for more information on security and locking
see page 42.)
INTERFACE Sub -Menu
External Interface
External Interface
Mode= Ethernet or USB