Zone tampered with followed by Zone number .
Restore
Zone Trouble
Zone with alert zone type activated
N/A
Zone Alert & Zone
A problem occurred with the Voice Engine, which was reset to
clear the problem.
N/A
Voice Reset
System is armed to Vacation Mode
N/A
Vacation Mode
Main Tamper, SEM, Door Station or Keypad tamper activation,
33-35=SEM 1-3, 49-52=Door Station 1-4 and
65-68=Keypad1-4.
Restore
33,49,65 Tamper
Alarm
Main Tamper, Bell tamper, Keypad, Door Stations or Zone
with 24-hour tamper zone type.
Restore
Tamper Alarm
More than six unsuccessful attempts to sign-in at the Keypad
while the system is armed.
Restore
Sign-In Tamper
System reset using Reset Button, Engineer Menu or
COMFIGURATOR.
N/A
System Reset
System Armed to one of the three modes.
N/A
System Armed
The system is disarmed and unset.
N/A
Security Off
Mains Power Removed
Restore
Power Failure
System attempted to dial telephone number 1-8.
N/A
Phone Number 1-8
Telephone line cut
Restore
Phone Trouble
Perimeter Alarm Activation followed by Zone number.
N/A
Perimeter Alarm &
Zone
Successful dialout to pager with correct acknowledgment
N/A
Pager Dial OK
Panic Alarm Activation followed by Zone number.
Restore
Panic Alarm & Zone
System Armed to Night Mode - Part Set.
N/A
Night Mode
Kissoff from Monitoring Station received
N/A
Monitoring Station OK
Valid user code 1-16 entered remotely using external phone.
N/A
(Name) Phone Call
Sign-In
Valid user code 1-16 entered using local phone or Keypad.
N/A
(Name) Sign-In Code
Ok
Messages were erased (either Greeting, Incoming, names or
all). Parameter can be seen only by Event Log upload by
Comfigurator
N/A
Messages Erased
1 Mailbox/User was deleted or all mailboxes erased.
Comfigurator upload of Event log will show the user deleted
N/A
Mailbox/Mailboxes
Erased
Sign-in code was changed for user number #
N/A
Mailbox # Sign-in
Code Changed
Intruder Alarm Activation followed by Zone number.
N/A
Intruder Alarm & Zone
System armed using the one-touch key or a key switch
N/A
Key Arm
UCM/GSM Network problem
Restore
GSM Trouble
Fire Alarm Activation followed by Zone number.
Restore
Fire Alarm & Zone
During Exit, the # key was pressed to force arm
N/A
Force Arm
The Engineer has entered the system using the Eng Access
code.
N/A
Engineer Menu
The Engineer has reset the system following Alarm Activation,
using * on Engineer Menu
N/A
Engineer Reset
(UK Only)
Description
Restore
Event
False Alarm on Disarming
This may be caused by connecting PIRs or Keypads to the S12V output instead of the 12V
terminals. S12V and 12V share the same terminal block. S12V is meant for detectors which
need to be reset on disarming, and is switched off for 5 seconds when the system is
Comfort II Supplementary Installation Manual
22
