GALEP-Programmer
FR Family MB91460 Series, Flash Programming, Doc. No. 002-05153 Rev. *A
26
5.1.3
Serial Asynchronous Programming with GALEP-4 Programmer
For serial asynchronous programming no adapter is needed. Connect the starterkit via serial cable to free COM
port on your PC and do jumper settings as described in following chapters depending on your board type.
Additionally set DTR signal as reset signal. GALEP-4 programmer has also to be connected to the PC to act as
kind of hardware dongle.
Figure 5-9: Serial Asynchronous Programming with GALEP-4 Programmer
Start the GALEP32 programmer software and use ‘Load’ command to load a bin or hex file. Select tab ‘Devices’
and browse to the correct device, e.g. MCU
Cypress
MB91F467D. Choose ASYNC for serial asynchronous
programming. Use
‘Select Device!’ button to accept current selection.
Use the functions now enabled on the bottom of the window to select action:
Program: write loaded mhx/bin-file to MCU
Verify: compare loaded file to Flash contents
Blank: do a blank check
Read: read-out Flash content
Erase: perform a chip erase
After selecting a operation, tab ‘Action’ is automatically activated. Press ‘Start’ button to start operation.
For further information on available settings in software and jumper settings on starterkits have a look at
‘Options”
‘MB91F467D Options” (or other MCU type) and ‘Device Help’.
