16
CY8CKIT-029 PSoC® LCD Segment Drive Expansion Board Kit Guide, Doc. # 001-55415 Rev. *K
Kit Operation
3.2.2
Programming a PSoC 3/PSoC 5LP Development Kit
This section provides details on programming the PSoC 3/ PSoC 5LP Development Kit.
The default programming interface for the board is a USB based on-board programming interface.
To program the device, follow the following steps:
1. Connect the DVK to PC using a USB cable connected at the programming USB connector J1
and wait until the DVK gets enumerated as DVKProg in case of CY8CKIT-030 and DVKProg5
incase of CY8CKIT-050LP, as shown in
Figure 3-7
.
Note:
The figures are shown for CY8CKIT-030. The same connections need to be done if
CY8CKIT-050LP is used.
Figure 3-7. Connect USB Cable to J1
2. Click on the code example,
LCD_Seg_Example1_Battery_Meter_030/ LCD_Seg_Example1_Battery_Meter_050LP, located
in Examples and Kits on the Start Page of PSoC Creator.
Figure 3-8. Start page
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from