7. Operation Controls and Functions
7.1 Front Panel
Transmitter
Receiver
①② ④ ③
⑨
⑩
⑧
IR 2
Blaster
IR 1
Extender
DC 48V
RS-232
Out
Power
HDCP
Link
Mode
CAT5e/6
In
CAT5e/6 to HDMI with LAN/PoE/IR CH-1109RX
Receiver
⑦
⑥
①
③ ④
⑤
⑩
⑧
IR 2
Extender
IR 1
Blaster
RS-232
In
Power
HDCP
Link
Mode
CAT5e/6
Out
HDMI to CAT5e/6 with LAN/PoE/IR CH-1109TX
Transmitter
⑦
⑥
①
Power LED: This red LED will illuminate when the power is connected with
AC wall outlet.
②
DC 48V: These slots are where you plug the 48V DC power supply into the
unit and connect the adaptor to an AC outlet.
③
IR 1/2 Blaster: These slots are to connect with the IR blaster cables
included in the package for IR signal transmitting.
④
IR 1/2 Extender: These slots are to connect with the IR receiver cables
included in the package for IR signal receiving.
⑤
RS-232 In: This slot is to connect with PC/laptop with D-Sub 9 pin cable for
RS-232 control system.
⑥
HDCP LED: This red LED will illuminate in when the input source signal
contains HDCP data.
⑦
Link LED: This yellow LED will illuminate when the both input and output
signal is connected.
⑧
Mode LED: This green LED will blinking when the device is processing data.
⑨
RS-232 Out: This slot is to connect to the device that wishes to be
controlled with D-Sub 9 pin cable for RS-232 signal to be execute.
⑩
CAT5e/6 Out/IN: These slots are to be connected with a single CAT5e/6
cable for data transmitting.
4