CYP CPHD-V4, Руководство по эксплуатации

Страница: 9 / 120

4
Once an active sink has been connected, the lower portion of the
display will change to indicate the current test pattern number and
name.
2
IR Window: Accepts IR signals from the included IR remote for control of
this unit only.
3 MENU Button: Press to enter the OSD menu, or to back out from menu
items.
4
ENTER/OPTION Button: Press to confirm a selection or to go deeper
into a menu item. When the selected function has optional selections, the
associated button’s LED will illuminate along with the +/▲ & −/▼ buttons.
5 +/▲ & −/▼ Buttons: Press to move up and down or adjust selections
within menus. These buttons will illuminate when the selected function
has values that can be adjusted up or down.
6
PATTERN Button: Within Pattern mode, press to enable selection of the
test pattern used. The +/▲ & −/▼ buttons will illuminate and are used to
select the new pattern. The new test pattern will automatically become
active after selecting it and pausing for 2 seconds. Additional variations (if
available) are selected by pressing the PATTERN button additional times.
Title-Safe Overlay: Within Analyzer mode, press to cycle through a
variety of “title-safe/action-safe” overlays.
Note: This feature is not available when the output resolution is set to
bypass mode.
7
TIMING Button: Press to enable selection of the output timing and
resolution used. The +/▲ & −/▼ buttons will illuminate and are used to
select the new timing. The currently selected timing will be shown on
the OLED display. The new timing will automatically become active after
selecting it and pausing for 2 seconds.
Force Bypass: In Analyzer mode, press and hold this button for 2
seconds to force the output to use Bypass mode.
Note: In Analyzer mode, please select the “Bypass” timing if you do not
wish for your source’s output signal to be scaled by the unit before being
sent to the display. The TIMING button’s LED will blink red when the
timing is set to Bypass.
8 ANALYZER/PATTERN Button:
Press to switch the unit between
Analyzer Mode (LED=Red) and Pattern Mode (LED=Blue).