CYP CPHD-V4, Руководство по эксплуатации

Страница: 13 / 120

8
6.4 Remote Control
The IR remote uses one out of 4 available
address channels for control of the test pattern
generator, allowing up to 4 to be located in the
same area while being controlled by different
remotes.
To configure this, select “IR Controller Address”
within the “Setup” section of the OSD’s main
menu.
Assign an address number (from 0 to 3) that
matches the setting on the remote that is to be
used with the unit.
The IR remote’s address can be set using the two
DIP switches located on the back of the remote, inside the battery cover. The
default factory setting is 0 (off, off).
1
Analyzer/Pattern: Press to switch between Analyzer Mode and Pattern
Mode.
2
EDID: Press repeatedly to switch between the available EDIDs for the
HDMI input.
3
Color Space: Press repeatedly to switch between the available color
space formats (RGB, YCbCr 4:4:4, YCbCr 4:2:2 & YCbCr 4:2:0).
4
HDCP SW.: Press to switch between supported HDCP versions or to
disable HDCP.
5
Format: Press to switch between DVI and HDMI output formats.
6
VGA~4K6G: Press to directly select the output resolution.
7 Output On:
Press to enable video output.
8
Output Off: Press to disable video output.
9 T− & T+:
Press ◄/► to select a new output resolution timing. Within the
OSD menu, press to adjust selections.
P+ & P−: Press ▲/▼ to change the current test pattern. Within the OSD
menu, press to move up and down.
CR-174
OK
Output On
Pattern
Analyser/
HDCP SW.
Output Off
Color Space Format EDID
T+
Menu
P+
Exit
P-
T-
Audio CH Hotplug Packet
Sink AVMute1 AVMute0
Source Audio T. Video T.
VGA WXGA WUXGA
480p 720p 1080p
1080i 4K3G 4K6G
Vol+ Vol- Mute
1
2
7
6
9
10
12
13
4
5
3
8
11
14