WARNING!
Note that there are risks involved in handling commercial detergent and rinse aid. Protective
gloves and goggles must be used when handling these products.
Follow the supplier’s safety regulations concerning the handling and storage of detergent and
rinse aid.
WARNING!
Always install protective caps and plugs when disconnecting a system for automated dosage.
Adjust the height and slide the dishwasher into place
1. Start by measuring the height from the floor to the bottom edge of the worktop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Lean the dishwasher forwards a little and adjust the rear foot with the screw at the front of the
dishwasher. Turn clockwise to lower or anticlockwise to raise.
4. Adjust the front feet by turning them clockwise to raise and anticlockwise to lower the dishwasher.
24 mm
16 mm
5. Check that there is an air gap of at least 3 mm between the underside of the worktop and the top
edge of the dishwasher.
6. Slide the dishwasher into place.
•
Pull in the inlet and outlet hoses and the power cable when the dishwasher is slid into place.
If automated dosage has been installed, carefully pull in the hoses and external cables for that
as well.
•
Check that the hoses have no kinks or sharp bends, and check that there is nothing that can
damage the hoses.
EN 87