Green - Unload
The dishwashing program is finished. The status light stays on for 15 minutes.
Stopping or changing a program
If you want to change program after starting the dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if the lid of the detergent dispenser has opened
(this happens automatically if an automated dosage system has been connected). Then select a new
program, press Start/Stop and close the door.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a while,
the dishwasher continues the program.
If the dishwasher is turned off due to a power failure
If the dishwashing program was not finished, the interrupted program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than 2
minutes.
Once the program has finished
Once the program has finished, "END" appears on the display.
At the end of the program one short signal will sound. Chapter Settings describes how to change this
function.
The dishwasher switches off automatically after the program ends. Shut off the water tap after each
use.
How to get the best drying results
•
Fully load the dishwasher.
•
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
•
Top up with rinse aid or increase the rinse aid dosage level.
•
Activate the Auto Open setting.
•
Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from the upper basket falling onto the dishes
in the lower basket.
EN 67
