Troubleshooting
Action
Type of fault on the display
Clear the drainage pump. See the chapter Care and cleaning. If
the problem persists, call the service department.
Overfilling water 1
F10
See “Water remains in the dishwasher” in the table “Problem”
below. If the problem persists, call the service department.
Water outlet fault
F11
Check that the water tap is on. If the problem persists, call the
service department.
Water inlet fault
F12
Turn off the water tap and call the service department.
Inlet valve leakage
F40
Remove the plug from the wall socket and call the service depart-
ment.
Heater fault
F41
Clean the coarse and fine filters. If the problem persists, call the
service department.
Clean the filters
(Water level fault)
F52
Turn off the water tap and call the service department.
Overfilling water 2
F54
Call the service department.
Circ. pump fault
F56
Check that the water tap is on. If the problem persists, call the
service department.
Water inlet fault
F67
Call the service department.
Circ. pump fault
F73
Press any button to clear the error message.
Action
Possible causes
Problem
Wait a moment then try again.
You have pressed the buttons
too soon after opening the door.
The buttons do not react when
pressed.
See the chapter Settings.
Child lock (button lock) activ-
ated.
Open the door. The buttons only
react to use when the door is
open.
The door is closed.
Clean with a dry or slightly
damp cloth.
The buttons are dirty.
Check that the baskets are cor-
rectly positioned horizontally.
The baskets are not correctly
positioned.
Cannot close door.
Check that the dishes are not
blocking the baskets from slid-
ing properly into place.
Press and hold Start/Stop until
the display shows "Program
started, close door".
The Start/Stop start button has
been pressed for too short a
time.
The dishwasher does not start.
Check.
The door is not properly closed.
Top up with salt. See the
chapter Care and cleaning.
Salt compartment empty.
EN 78