CYCLOPS tornado osd series, Руководство пользователя

Страница: 6 / 18

Options
Setup
instructions
Comments
PAGE 1
BAT SCALE mAh alarm value
When the power consumption reaches the set value in flight,
the battery capacity symbol and value will flash to indicate it.
The mAh consuming can be adjusted by 0%-200%.
RESET CURRENT
Reset the current
sensor to zero At first use or after replacing the current sensor, it needs to
set this option
SEV CENTER
Servo center
confirmation
Please make a test flight of the model aircraft test and adjust
the center point of the control surface before confirming this
option. After replacing the model plane, the servo centers
need reconfirmation.
REV
AIL
Aileron reverse
setting With error-free connection and power, switch the flight mode
to PA, sway model aircraft to the lateral and pitch direction,
check the rudder of each control surface is correct, if the
rudder is adverse, adjust the option to make it right.
ELE
Elevator reverse
setting
ELEVON
ELEVON linkage
function
It is used for flying wing model planes. When selecting Y, you
must close the mixed controls of the ELEVON on the remote
transmitter.
TRIM
Fine adjustment
of main board
installation
levelness
Put the model aircraft with TORNADO OSD flat and power it
on, observe posture angle parameters at the surface. If due to
the installation errors, the P, R parameters are not 0, you can
adjust this option, such as P-3, R+5, then adjust the P to -3 , R
to +5 in the TRIM, exit the menu and observe the posture
parameters again , until all are 0. This only needed to be set
once after the installation of OSD main board, unless the
replacement of aircraft or reinstallation of OSD main board.
Auto-calibration of stabilization position function is added, put
your plane on the ground horizontally, and enter this option,
the OSD will reset the center point of roll and pitch.
RESET GYRO Gyro calibration
It needs to recalibrate when it is used for the first time
（
very
important
！！！）
or it is placed for a long time, during
calibration, OSD main board must be placed horizontally,
and strictly remains still
！！！
RSSI
Signal strength
indicator
You need to confirm the max and min value in the
configuration menu. When the RSSI value is under 5%, the
display will disappear, and the radio icon will flash to warn
you that the signal is too low or lost. The RSSI will not show up
when the min and max settings of RSSI are equal.