CYCLOPS tornado osd series, Руководство пользователя

Страница: 10 / 18

Directions for use
1
、
We recommend the clients to use electric power model airplane with good
stability.
2
、
Place TORNADO OSD in your plane horizontally, keep the logo plane’s heading
point to your plane’s heading. If the plane slope over 15 degree, the OSD will keep
display the boot interface until you put the plane horizontally.
3
、
For prop planes, it’s important that the tube be placed so that it is not directly in
the plane’s prop-wash, which will result in erroneous readings. The best place to
install the tube is on the leading edge of the wing several inches out from the
fuselage. For jets, gliders, or “pusher” prop planes, the nose cone often provides a
perfect mounting location, as shown in Figure 1.
1
4
、
As GPS beginning to search satellites, the satellite number is indicated by the GPS
strength icon on the upper right corner. A flashing icon indicates weak or
unreliable GPS strength and cannot be used as positioning parameters. With
good GPS signal, the satellite searching would last 1-5 minutes depending on
different circumstances.
5
、
Flying mode shift shall be connected to any knob ratio channel on the remote
controller. Under different modes, the flying interface will display different
information, PA (auxiliary manual pilot mode), AUTOPILOT (auto pilot mode), and
RTH (Auto return mode). At auto pilot mode, turn the knob AUTOPILOT to PA and
quickly back to AUTOPILOT, the system will shift to the next waypoint, as shown in
Figure 2.