CYCLOPS tornado osd series, Руководство пользователя

Страница: 12 / 18

amount, the plane will fly left (right) at 45 degree slope, if the elevator steer is in
100% amount, the plane will lift (lower) at 20 degree angle. Until the control lever
returns to the neutral, the system will lock and keep the course and altitude at the
moment.
10
、
Before taking off, press reset button to reset all parameters. (This operation
will reset altitude, distance, timer, current and mAh consumed).
11
、
When OSD detect 0 voltages on the power battery, it will not display voltage,
current
and mAh consumed of power battery.
12
、
TORNADO OSD can display RSSI voltage (receiver signal strength indicating
voltage) measuring range: 0.1-3.3V, when this voltage is below 0.1v, OSD will not
display this parameter. In order to display RSSI voltage, the user has to open the
receiver and to solder wires by him, so the manufacture bears no responsibility for
all consequent damage due to this operation.
13
、
Screen Display Control Surface (DIS port) can be connected to any switch on
the remote control unit to switch between fighter and concise surfaces. In concise
surface, directions designation of returning to the take-off point indicates H in the
screen represent the take-off point; When H is in the middle and not flash, it
indicates the plane is heading directly to the take-off point; When the H is in the
middle and flash, it indicates the plane is flying 180 degree away from the
take-off point. Switch between interfaces with the remote control will not be
stored, as shown in Figure 4.
4
14
、
When TF card is inserted into the system and the system detects satellite
signal, press for seconds UP button, and SD symbols will appear on the upper-left
corner and flash. At this point, the card starts storing the system data. Press Reset
and the card will restart storing the system data. If you want to end data storage,
press UP button for 3 seconds and SD card symbol stops flashing, and you end
data storage.