129
SYMPTOM
ACTION
Recheck the address of the computer you are switching to.
Ensure that each unit has a unique unit address.
Ensure that you are not trying to connect to a computer over four
units away.
Recheck the XPAC for proper configuration.
Ensure that each unit has a unique unit address.
Ensure that all transmitter and receiver boards are plugged in
completely. Make sure all connecting screws are tight.
Ensure that the jumpers on the transmitter and receiver are set for
the correct distance.
Ensure that the cable distance for the affected computer is less
than 500 feet.
Recheck the XPAC for proper configuration.
Two or more transmitters within one unit are set with conflicting unit
addresses or are conflicting with the redundant power supply. See
Chapter 2 for details.
If only one transmitter is installed in the chassis, check the Intelli-
gent Power Supply address. See Chapter 2 for details.
Channel
Cannot Be
Selected in
multi unit
system
Video is
Superim-
posed with
Another
Computer's
Video
Video is
Poor or
Degraded
Transmitter
LEDs are
flashing
Microphone
Does Not
Work
Ensure that the connected computer has multimedia cable with the
microphone connected.
Recheck the microphone connection to the unit and make sure it is
secure.
Ensure the microphone is supported by the unit. See “Limitations
and Restrictions” in Chapter 1.
Check all volume controls and make sure the volume is set high
enough to be heard.
Speakers Do
Not Work
Ensure you have selected a channel with speaker control.
Recheck the speaker connection to the unit. Make sure it is tight.
Ensure the speakers have enough power to operate with the unit.
See “Limitations and Restrictions” in Chapter 1.
Check the volume controls and make sure the volume is set high
enough to be heard.
