CYBEX autoview 200, Инструкция по установке и эксплуатации

Страница: 20 / 48

AutoView 200 Installer/User Guide
14
System Control &
Maintenance
Key Sequence Action
<CM> K n <Enter> Sets the keyboard scan set where n is a scan set number 1-3.
<CM> MR <Enter> If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a standard PS/2 mouse driver.
<CM> MW <Enter> If you hot-plug your mouse cable, you may experience a loss of mouse
signal. Use this command to restore the signal if you are using a PC
with a Microsoft IntelliMouse or other wheel mouse driver.
<CM> AV <Enter> Displays the current firmware version of your AutoView 200.
<CM> SG <Enter> Enables the scan Go command (By address only)
<CM> SH <Enter> Enables the scan Halt command
<CM> M+ <Enter> Enables mouse suspension of scanning
<CM> M- <Enter> Disables mouse suspension of scanning
<CM> H1 <Enter> Changes the hot-key sequence to the default: (NumLock, -)
<CM> H2 <Enter> Changes the hot-key sequence to the 1st alternate: (NumLock, *)
<CM> H3 <Enter> Changes the hot-key sequence to the 2nd alternate: (CTRL, ~)
<CM> OSD0 <Enter> Disables the OSD Sequence
<CM> OSD1 <Enter> Changes the OSD sequence to the default: (CTRL, CTRL)
<CM> OSD2 <Enter> Changes the OSD sequence to the 1st alternate: (Alt, Alt)
<CM> OSD3 <Enter> Changes the OSD sequence to the 2nd alternate: (Shift, Shift)
<CM> <CM>
<CM> <CM> <CM>ZM<Enter>
<Enter>
<Enter> <Enter> <Enter> Use this command to resynchronize the mouse after a device or
computer hot-plug. Repeat, if necessary, until synchronization is
re-established.
Note: Using this command while the mouse is operating
correctly will cause the mouse to lose sync.
The following commands are used for system control and maintenance.
Enter the command sequences to perform the actions described in the
table below.