Cyber Suite CYB-KLED, Руководство по установке, Страница: 14 / 32

11 CYB-KLED CyberSuite Installation Manual
DEVICE CONFIGURATION
Device Configuration Mode Access
Before the CyberSuite LED Keypad module will communicate it must
be assigned an address and programmed with specific options as to
how it will operate. This is achieved by accessing the device
configuration menu.
The device configuration menu can only be accessed in the
FIRST 2 SECONDS when the device powers up. It is not able
to be accessed when the system is operational.
To gain access to the device configuration menu, apply power to the
device, and within the first 2 seconds after the four beep tone is
heard, press the [CLEAR] key, followed by the [ENTER] key.
The
INSTALL
LED will then be lit to notify that device configuration
mode has been entered. You can then press the key corresponding to
the menu required from the following list.
Address Selection ([MENU] , [1])
The address selection sets the address of the CyberSuite LED
Keypad, this address must be a unique address on the system from 1
to 250.
Enter the address with the following keypress sequence:
[MENU] , [1] , [ADDRESS 1] , [ADDRESS 2], [ADDRESS 3], [ENTER]
The address will now be displayed on the zone LED’s in binary form once
all 3 digits have been entered.
ALL 3 Digits MUST be entered when programming an address.
This means that for addresses below 100, you must enter [0]
then the 2 digits of the address. For addresses below 10, you
must enter [0] , [0] followed by the address digit.