Loading Media
Spectra II
30
Operating Manual
08.17
A
B
C
D
E
G
H
F
I
Figure 8
1. Open the printer cover.
2. Open the printhead (G) by turning the pressure lever (H)
anticlockwise.
Spectra II 216!
Pull centring plate (I) outwardly.
3. Remove the outside label mounting plate (A).
4. Load the label roll with inner winding onto the unwinding roll (B).
5. Attach again the label mounting plate (A).
6. Lead the label material below the label guiding (D).
Take care that the label runs through the photocell (E).
Spectra II 216!
Lift centring plate (I) again upwards.
7. To move the printhead (G) down, turn the pressure lever (H) in
clockwise direction until it locks.
8. In front of the printhead the tear off edge (F) is visible.
9. Enter the offset value in menu
Printer Initialisation/Tear off
.
10. Adjust the limit stops (C) of the label guiding to the width of
material.
11. Close the printer cover.
Loading label roll in
tear-off mode