Cutters Edge CE-1270RH SERIES, Руководство оператора

Страница: 11 / 35

CUTTERS EDGE
10
770
/970/12
7
0 Model
Cutting Blades
Abrasive blades for different materials
Blade type Material
Concrete blade
Concrete, asphalt, stone masonry,
cast iron, aluminium, copper, brass,
cables, rubber, plastic, etc.
Metal blade
Steel, steel alloys and other hard
metals.
!
WARNING! Do not use abrasive blades
with water. The strength is impaired
when abrasive blades are exposed to
water or moisture, which results in an
increased risk of the blade breaking.
Diamond blades
General
!
WARNING! Never use a diamond blade
to cut plastic material. The heat
produced during cutting may melt the
plastic and it can stick to the cutting
blade and cause a kickback.
Diamond blades become very hot when
used. An overheated blade is a result of
improper use, and may cause
deformation of the blade, resulting in
damage and injuries.
• Diamond blades consist of a steel core provided with
segments that contain industrial diamonds.
• Diamond blades ensure lower costs per cutting
operation, fewer blade changes and a constant cutting
depth.
• When using diamond blades make sure that it rotates
in the direction indicated by the arrow on the blade.
Diamond blades for different materials
• Diamond blades are ideal for masonry, reinforced
concrete and other composite materials.
• Diamond blades are available in several
hardness classes.
• Special blades should be used when cutting
metal. Ask your dealer for help in choosing the
right product
• Cutters Edge brand diamond blades can be used
to cut all materials and can be used in dry or wet
cutting situations..
De-glazing diamond blades
• Always use a sharp diamond blade.
• Diamond blades can become dull
or glazed when the wrong
feeding pressure is used or when cutting certain materials such
as heavily reinforced concrete. Working with a dull diamond
blade causes overheating, which can result in the diamond
segments coming loose.
• De-glaze the blade by cutting in a soft material such as
sandstone or brick.
Diamond blades for dry cutting
• Although no water is required for cooling, dry cutting blades
must be cooled with air flow around the blades. For this
reason dry cutting blades are recommended only for
intermittent cutting. Every few seconds of cutting the blade
should be allowed to run 'free” with no load to allow the air flow
around the blade to dissipate the heat.
Diamond blades for wet cutting
• Wet cutting diamond blades must be used with water to keep
the blade core and segments cool during sawing.
• Wet cutting blades should NOT be used dry.
• Using wet cutting blades without water can cause excessive
heat build-up, resulting in poor performance, severe blade
damage and is a safety hazard.
• Water cools the blade and increases its service life while also
reducing the formation of dust.
Transport and storage
(If using abrasive blade)
• Do not store or transport the power
cutter with the cutting blade fitted. All
blades should be removed from the
cutter after use and stored carefully.
• Store cutting blades in dry, frost free
conditions. Special care should be taken
with abrasive blades. Abrasive blades
must be stored on a flat, level surface. If
an abrasive blades is stored in humid
conditions, this can cause imbalance
and result in injury.
• Inspect new blades for transport or
storage damage.