Cutters Edge CE-1270RH SERIES, Руководство оператора

Страница: 17 / 35

CUTTERS EDGE
770
/970/12
7
0 Model
Operating
• Hold the saw with both hands; keep a firm grip with
thumbs and fingers encircling the handles. The
right hand should be on the rear handle and the
left hand on the front handle. All operators,
weather right or left ha nded shall use this grip.
Never operate a power cutter holding it with only
one hand.
• Stand parallel to the cutting blade. Avoid standing
straight behind. In the event of a kickback the saw
will move in the plane of the cutting blade.
• Maintain a safe distance from the cutting blade
when the engine is running.
• Never leave the machine unsupervised with the
motor running.
• Never move the machine when the cutting
equipment is rotating. Make sure that the blade
has come to a complete stop before the machine
is put on the ground. The machine is equipped with
a friction retarder to shorten the blade stop time.
• The guard for the cutting equipment should be
adjusted so that the rear section is flush with the
work
piece. Spatter and sparks from the material
being cut are then collected up by the guard and
led away from the user. The guards for the cutting
equipment must always be fitted when the
machine is running.
• Never use the kickback zone of the blade for
cutting . See instructions under the heading
"Kickback".
• Keep a good balance and a firm foothold.
• Never cut above shoulder height.
• Never cut from a ladder. Use a platform or scaffold
if the cut is above shoulder height. Do not
overreach
• Move the blade slowly forwards and backwards to
achieve a small contact area between the blade
and the material to be cut. This reduces the
temperature of the blade and ensures effective
cutting.
Managing dust
The machine is fitted with a low flushing water kit that
offers maximum dust suppression.
Use wet cutting blades with water cooling when
possible for optimal dust management. See
instructions in the section "Cutting blades".
Adjust the water flow using the valve to bind the
cutting dust. The volume of water required varies
depending on the type of job at hand.
If water hoses loosen from their supply sources, this
indicates that the machine is connected to a water
pressure that is too high. See instructions under the
"Technical data" heading for recommended water
pressure.
• Stand at a comfortable distance from the work
piece.
• Check that the blade is not in contact with
anything when the machine is started
• Apply the cutting blade gently with high rotating
speed (full throttle) Maintain full speed until cutting
is complete.
• Let the machine work without forcing or pressing
the blade.
• Feed down the machine in line with the blade.
Pressure from the side can damage the blade and
is very dangerous.
16