Cutters Edge CE-1270RH SERIES, Руководство оператора

Страница: 13 / 35

CUTTERS EDGE
12
770
/970/12
7
0 Model
Fuel Handling
!
WARNING! Running an engine in a confined or
badly ventilated area can result in death due to
asphyxiation or carbon monoxide poisoning.
Use fans to ensure proper air circulation when
working in trenches or ditches deeper than one
meter (3 foot).
Fuel and fuel fumes are flammable and can
cause serious injury when inhaled or allowed to
come in contact with the skin. For this reason
observe caution when handling fuel and make
sure there is adequate ventilation.
The exhaust fumes from the engine are hot
and may contain sparks which can start a fire.
Never start the machine indoors or near
combustible material!
Do not smoke and do not place any hot objects
in the vicinity of fuel.
Fuel
Gasoline
• Use good quality unleaded gasoline.
• The lowest recommended octane grade is 87
((RON+MON)/2). If you run the engine on a
lower octane grade than 87 so-called knocking
can occur. This gives rise to a high engine
temperature and increased bearing load, which
can result in serious engine damage.
• When working at continuous high revs a higher
octane rating is recommended.
NOTICE! The machine is equipped with a two-stroke engine
and must always be run using a mixture of gasoline and
two-stroke engine oil. It is important to accurately measure
the amount of oil to be mixed to ensure that the correct
mixture is obtained. When mixing small amounts of fuel,
even small inaccuracies can drastically affect the ratio of
the mixture.
Two-stroke oil
• For best results and performance use Cutters Edge two-
stroke engine oil, which is specially formulated for our air-
cooled two stroke-engines.
• Never use two-stroke oil intended for water-cooled
engines, sometimes referred to as outboard oil (rated TCW).
• Never use oil intended for four-stroke engines.
K 770 OilGuard
• Use HUSQVARNA OilGuard two stroke oil.
Mixing
• Always mix the gasoline and oil in a clean container
intended for fuel.
• Always start by filling half the amount of the gasoline to
be used. Then add the entire amount of oil. Mix
(shake) the fuel mixture. Add the remaining amount of
gasoline.
• Mix (shake) the fuel mixture thoroughly before filling the
machine’s fuel tank.
• Do not mix more than one month’s supply of fuel at a
time.
Mixing ratio
100:1 for Cutters Edge synthetic oil. 50:1 for petroleum
based oils. For other brand synthetic oils, follow the
manufacturer’s instructions for mix ratio.