Servo Mounts
Servo Mounts
Servo Mounts
Servo Mounts
Servo Mounts
-Parts for
Steps
#1
5242 Qty 1
Large Servo Saver
5225 Qty1
2” Ti Turnbuckle
1:1
5253 Qty 4
4-40 x 3/8 BH Screw
1:1
5263 Qty 5
4-40 x 3/8 FH Screw
8122 Qty 2
Ball Stud
5240 Qty2
Servo Mount
STEP #1
- Attach 5240 Servo Mounts to your steering servo in the position shown
using 5253 Screws and 5212 Washers.
- Thread 8122 Ball Stud into the upper-most center hole in the 5242 Servo
Saver and 5217 Locknut as shown.
NOTE: Using inner hole on servo saver will decrease steering speed if desired.
- Determine which of the Spline Inserts are correct for your servo by pressing
it over the drive on the servo. Align the servo so it has equal throw in both
directions, you may need to do this with the radio system powered.
- Press the Servo Saver onto the Spline Outdrive and attach the Servo Saver
using the screw that came with your servo.
3234 Qty2
Spacer
UPPER
HOLE
5253
SCREW
5242
SERVO SAVER
5212
WASHER
8122
STEP #2
- Mount the servo to the chassis using 5263 Screws in the 3rd row of
holes from the right edge of the chassis.
- Thread the 5235 Ball Cups onto the 5225 Turnbuckle. Snap the Ball
Cups onto the Ball Studs on the Servo Saver and the Bell Crank.
- Adjust Draglink length so that the Servo Saver is 90 Degree to the Drag
Link AND the Bell Cranks are parallel to the Chassis at the same time.
- Attach 3209 Antenna Mount into a vacant hole in the chassis.
5235
5225
5217 Qty 8
4-40 Lock Nut
5217
5212 Qty 4
Washer
5235 Qty 2
Ball Cup
3209 Qty1
Antenna Mount
- Steering movement should be bind free
except for the restriction of the servo.
TIP
Remove extra slop in the Ball Cups and Ball Studs by placing
the plastic bag these parts came in between the Cup and Ball Stud
as you snap them together. This will create a perfect shim and
make the steering unit very tight. Linkages should still pivot freely.
5235
Bag K
Bag K
Bag K
Bag K
Bag K
Battery Mounts
Battery Mounts
Battery Mounts
Battery Mounts
Battery Mounts
-Parts for
Battery
Mounts
5263 Qty 8
4-40 x 3/8 FH Screw
1:1
3266 Qty 2
Li-Po Locator
3009 Qty 1
Strap Buckle
3009 Qty 2
Battery Strap
- LOCATE THE SCREWS TO
FASTEN 3266 TO CHASSIS
IN THE 4TH AND 6TH HOLES
FROM THE LEFT EDGE OF THE
CHASSIS.
3266
- Insert the 3266 Lipo Locator thru the small loop on each
3009 Battery Strap. Mount to chassis using 5263 Screws.
3009
STRAP BUCKLE
- Insert each tab of the 3009 Battery Strap thru the Strap Buckle.
Simply pull the strap tabs tight to secure your battery into the car.
5240
SERVO
MOUNT
90
DEGREE
