D105
Service Hose Crimper
7
LUBRICATION PROCEDURE
Photo # 1
Place a thin layer of CrimpX oil (supplied with crimper) or a high
pressure molybdenum high pressure grease on the surface the dies
sit on (as shown in photo # 1).
Grease Point # 2
Before sliding the compression ring over the correct die set, place
a thin layer of CrimpX oil (supplied with crimper) or a high pres-
sure molybdenum high pressure grease on the entire area that dies
come in contact with on the inner diameter (as shown in photo # 2).
If Breaking Die Screws Often:
Continue to lubricate / grease as
explained above in addition to lubricating each die finger individually
(as shown in photo # 3A).
If Compression Ring Sticks:
The die fingers must be lubricated on
each segment that comes in contact with the compression ring (as
shown in photo # 3B).
Note:
Lubrication is not required before each crimp.
Typical lubrication is after 100 crimps.
Grease Point # 1
Insert the pressure plate into the bottom flange of the crimper, making
sure that it is seated squarely into the bottom flange.
Photo # 2
Photo # 3
A
B
