D105
Service Hose Crimper
14
Step 5:
Set the
Metric Micro-Crimp Adjuster
at “0”.
Note:
Set the Micro-Crimp Adjuster at “100” for the Standard Micrometer.
Set the Micro-Crimp Adjuster at “95” for the DC Micrometer.
Step 6:
Depress and hold the Start/Stop switch, until the Die set is
completely closed and oil pressure has built up in the hydraulic cylinder.
If the ram extends, the dies are completely closed, the pump builds
pressure (The sound of the pump will change) when the micrometer
touched the electronic red button as shown, “count one mississippi” the
automatic stop switch will shut the pump off, and the ram will return to
the retracted position the crimper is correctly calibrated.
Step 7:
If the above conditions are not met, the crimper requires
recalibration, hold the micrometer barrel with a 5/16 inch open end
wrench and rotate the stem either in or out with a 5/32 inch hex key wrench.
Note:
1/4 turn of screw will change crimp diameter approximately
0.008".
• Rotating the stem out of the barrel decreases the time required for
the pump to shut off.
• Recheck calibration.
CALIBRATION CHECK PROCEDURE
