MHW 0008 – DK 1695 | Version 002 – 21/08/2019 | custo med GmbH
2
Holter
Hardware, description of device for custo watch
[2] Holter hardware, custo watch |
page 10
2.5.4
Operating the custo watch display
Standby
The custo watch is in idle mode, no recording is in progress. If the custo watch is
not connected to the PC, the time and date can be displayed by briefly pressing the
grey button.
If the custo watch is connected to the PC via the custo docking station, the battery
capacity of the custo watch and the corresponding custo guard ECG transmitter
(if it is also on the custo docking station) can be displayed by briefly pressing the
grey button. If there is sufficient battery capacity for a 24-hour recording period,
a checkmark appears for the corresponding device. The progress bar at the lower
edge of the display continues to run until both devices are fully charged (maximum
battery capacity).
Starting a recording manually
It is only necessary to manually start a recording if the custo watch was prepared
in custo diagnostic with the Start later option. As long as both devices are in the
custo docking station after the Start later option has been set, the battery capacity
of the devices can be displayed on the display (by briefly pressing the grey button).
To ensure a full 24 hour or 72 hour recording, both devices must be sufficiently
charged.
If the custo watch is outside the custo docking station, the display is switched on
by briefly pressing the grey button and the Start? query appears after the date
and time have been displayed. The recording is started by briefly pressing the grey
button again.
As soon as the recording is in progress, the duration of current recording is shown
at the top right of the display. The radio symbol (the first symbol at the top left)
appears when a connection to the ECG transmitter could be established. The ECG
symbol (the second symbol at the top left) appears when QRS complexes are
detected, i.e. the ECG transmitter is fitted on the patient. The display goes out after
a few seconds.
Setting a marker in the recording
The patient is able to set markers during the ECG recording, for example if feeling
unwell, in cases of stress or at special events.
The display is switched on by briefly pressing the grey button. The Mark? query
appears by briefly pressing the grey button again. The marker is set by briefly
pressing the grey button again and the confirmation Marked
is displayed. This
is acknowledged by briefly pressing the grey button and then closed. The display
shows the duration of current recording, time and date again. If no further input is
made, the display goes out after a few seconds.
