Electrical Connection
Connection to a Junction Box
Connect the power cable wires to the terminals in
the junction box and replace the cover. See the
ELECTRICAL SCHEMATIC
for the power supply
requirements.
INSTALLATION INSTRUCTIONS
II14
Connecting the Brewer Wiring (Units That Come from
the Factory Without a Power Cord Attached)
Brewers With Power Connector Mounted to the Back
11
$POOFDUB$*&$QPXFSDPSE OPUTVQQMJFE
compatible with the electrical outlet installed in the
GBDJMJUZBOEUIBUNFFUTTQFDJmDBUJPOT
((&.*/45"--"5*0/*/4536$5*0/4ø
D
WARNING:
Do not connect the power cord to the
power supply until instructed to do so.
WARNING:
Turn off power to the junction box at
the circuit breaker panel and lock out and tag the
circuit breaker before connecting the power cable
to the junction box.
Brewers With Strain Relief Mounted to the Back
12 Remove the front cover by removing the screws that
hold it in place.
13 Loosen the strain relief on the back of the brewer.
Brew
deck
Front
panel
&RQ¿JXUDWLRQYDULHV
ZLWKPRGHO
:LULQJ
label
7HUPLQDO
block
&RQ¿JXUDWLRQYDULHV
ZLWKPRGHO
7HUPLQDO
block
or
Power cable
IURPEUHZHU
14 Feed the power cable into the brewer. The brewer may
be wired for connection directly to a junction box or for
use with a power plug that connects to an electrical
outlet meeting the brewer
SPECIFICATIONS
.
15 Connect the wires on the power cable to the terminal
CMPDLJOTJEFUIFCSFXFSBTTQFDJmFE4FFUIF
ELECTRICAL SCHEMATIC.
16 Tighten the strain relief and replace the front cover.
