Part No. 4801-5120 Rev. 1-2020
Mega-Cool System
Page 29 of 48
Mega-Cool 10'-80' Corner, End-Mount In-Line Pump System
End In-Line Pump Kits
(Complete Assembly)
INSTRUCTIONS
1. Assemble Mega-Cool Systems following the procedures in this
manual.
2. At the corner of the building, connect the two systems with 8" PVC
elbow section and 1-1/2" PVC elbow section as shown in diagram
above.
3. Locate reservoir and In-Line Pump at one end of Mega-Cool System
as shown in diagram above. Follow instructions on pages 20 & 21 to
install In-Line Pump & water supply. Use In-Line Pump support
brackets and wood platform to support In-Line Pump and strainer
basket.
4. Installation complete.
NOTES:
1. One side of the system can be longer than the other
side as long as the TOTAL system length does not
exceed 80 feet.
2.
Pipe is in 10’ Length. If the cumulative distance of the
systems from the corner is greater than 10’, additional
pipe may be required.
3. Excessive turns/elbows in pipe will reduce water flow
and stress the pump.
8” PVC Elbow
1021-6004
Pipe
1008-
0101 8”
PVC
1-1/2" PVC
Elbow Section
1021-0106
Flared end of
pipe
NOTE
: 8” pipe is flared on
one end to connect to
another pipe.
1-
1/2” PVC
1008-0104
1-
1/2” to 1-
1/4
Coupling
1021-6016
Union
1021-
0110
NOTE
: Mount the Corner System level.
The End-Pump System shown below is two Mega-Cool
Systems which operate from a single water supply & pump
located at one end of System as shown in diagram below.
