23
further display functions
Reset
To reset the daily data press the U-button for 4 seconds.
The display is completely reset by pressing the AC-button
(g+h)
(with
a pointed object) on the bottom side of the display.
Fault Clearance
There are no values on the display or the values are defective: Press
the AC-button (with a pointed object) on the bottom side of the dis-
play and check or replace the battery.
A
Before changing the battery note down the TOTALS. All
settings must be reset subsequently. If the seal ring is
loose, re-insert it.
operating the levels of assistance
The CUBE EPO pedelec assistance is switched on by pressing the top
O-button at the control element (Power button). It starts with the Eco
level and can be switched through to the Power level by pressing
O-button
(e)
.
By pressing the lower U-button on the control element you can
change to a lower level of the CUBE EPO pedelec assistance, i.e. from
the Power level to the OFF mode by pressing the U-button
(f)
. From
the OFF mode you can change into the recuperation mode by press-
ing the lower U-button once again.
A
In recuperation mode the rechargeable battery can be
recharged to a certain extent, e.g. when riding downhill.
This produces a gentle deceleration of the pedelec. Keep in
mind that riding in recuperation mode increases the roll-
ing resistance of your CUBE EPO pedelec.
g
Do not activate the system in stationary, when applying
force on the pedal. The measuring sensors of the CUBE
EPO pedelec measure this force and switch on the assist-
ance directly. An unintended setting off with the CUBE EPO
pedelec could not be excluded in this case. Risk of accident!
f
h
e
g
Cube_EPO_Gesamt_EN_2011-05.indd 23
11.05.2011 10:11:29
