2b. Input ID
Manual ID input is shown here.
Press Up or
Down
to select, press
Esc
to cancel, and press
Enter
to
select numbers or letters. Different
ID digital rules are set to different type
of sensors depending on the make,
model and year of vehicle. Therefore,
the ID setup processes are different,
too. Specific operating processes
are determined on the screen. After
the correct ID numbers are entered,
Screen 1 will be displayed.
When you see Screen 2, you can
proceed with sensor programming.
Place the CUB PUR-TPMS Sensor at
the top of the tool and press
Enter
.
Important Notice:
Please put other sensors at least 15 feet
away or there might be some interference
and the incorrect sensor may be programmed.
When “Program Succeed...” is
displayed on the screen and two
beep tones are heard, the sensor has
been programmed successfully.
Just as mentioned on page 15, you
can go back to the
Scan
function
menu to double check if the ID
downloaded is correct.
Screen 1
Screen 2
Section 5: Programming Function Menu
16
800-445-0179
©2008 TR
