Cub Cadet THE TANK S6031, Руководство оператора

Страница: 10 / 48

Assembly & Set-Up
3
10
Contents of Crate
One Zero-Turn Tractor • One Zero-Turn Tractor Operator’s •
Manual
One Deck Wash Hose Coupler •
One Engine Operator’s Manual •
Tractor Preparation
Remove the upper crating material from the shipping pallet, and
cut any bands or tie straps securing the tractor to the pallet.
Use the lift handle to raise the deck to its highest position.
Engage the transmission bypass valves on each side of the
tractor; then carefully roll the tractor off the shipping pallet.
The transmission bypass valves (one for each the RH and LH
transmission) are located just in front of the engine. Disengage
the bypass valves. See Fig. 3-1.
NOTE:
When closing dump valves, finger tighten and snug with
wrench, only. Valve seat could be damaged if overtightened.
Remove the deck wash system nozzle adapter from the manual
bag and store for future use. Cut the wire tie holding the chute
deflector up and discard any packing material.
Bypass Valve
Left Side Pump
Figure 3-1
Install Roll Over Protective System (ROPS)
The Roll Over Protective System (ROPS) has not been installed
on your unit for shipping purposes. Using the hardware found in
the Roll Over Protective System container, install it on your unit
as follows:
Insert each of the lower section ROPS tubular “posts into 1.
the brackets welded to the unit main frame. See Fig. 3-2.
NOTE:
The ROPS pivot holes should be positioned toward
the rear of the unit. See Fig. 3-2.
Insert the carriage bolts ( 2. 1⁄2 -13 x 3.25) (one per side) from
the front toward the rear. See Fig. 3-2. Alternately from the
rear toward the front if access is restricted.
NOTE:
The mounting hardware is accessible from the rear
of the machine with the use of extensions. Also, access can
be gained by reaching in from the sides over the tires and
under the fuel tanks.
Three holes are provided on each side. Use the Upper hole
3.
and one of the other two remaining holes that is easily
accessible. Install the flange lock nuts, but do not tighten.
See Fig. 3-2.
ROPS Posts
Carriage
Bolt
Frame Brackets
Flange
Lock Nut
Figure 3-2