Cub Cadet J466, Руководство оператора

Страница: 21 / 32

21
8. Remove the clamp from the fuel line. The filter
should begin to fill will diesel fuel.
9. Slowly turn the air bleed knob counterclockwise until
fuel begins to seeps out around the bleed knob. Turn
the air bleed knob clockwise to close. Refer to Figure
12.
10. Remove the catch container and properly dispose of
the diesel fuel.
11. Start and run the utility vehicle’s engine for a short
period to fully bleed any residual air from the filter,
fuel lines, and injection pump.
Engine Breather Service
The engine breather should be changed after every
2000 hours of engine operation. Contact your Cub
Cadet dealer.
Fuel Injector Nozzle Service
The fuel injector nozzles should be checked and
serviced after every 2000 hours of engine operation.
Contact your Cub Cadet dealer.
1. Stop the engine and raise the passenger seat by
removing the wing nut securing it to the frame.
2. Place a suitable container beneath the filter drain
valve. See Figure 12.
3. Turn the filter drain counterclockwise to open. Allow
the water at the bottom of the filter to drain until only
pure diesel fuel drains from the valve. See Figure 12.
4. Turn the filter drain clockwise to close.
5. Slowly turn the air bleed knob counterclockwise until
fuel begins to seeps out around the bleed knob. Turn
air bleed knob clockwise to close. Refer to Figure 12.
Changing The Fuel Filter
Replace the fuel filter cartridge after every 500 hours of
operation.
NOTE
: There is no shut off valve in the fuel system. To
stop the flow of fuel while replacing the filter, it will be
necessary to carefully clamp the fuel line between the
fuel tank and the filter.
1. Place a suitable container beneath the filter drain.
2. Clamp the fuel line just to the rear of the fuel filter. See
Figure 12.
3. Open the filter drain and drain the filter into the
container below. Close the filter drain.
4. Turn the filter approximately 1/4 turn counter-clock-
wise (as viewed from bottom) to align the unlock
icons.
5. Pull the filter cartridge straight downward to remove
from the filter body.
6. Align the unlock icons of the new filter cartridge and
filter body, and push the new filter cartridge fully up
into the filter body.
7. Turn the new filter cartridge approximately 1/4 turn
clockwise to lock.
NOTE : The lock icons on the body and cartridge should
be aligned or nearly aligned.
5
Servicing
Your
Utility
Vehicle
������
�����
����
�����
�������
�����
����������
����
Figure 12
NOTE: There is no shut
off valve in the fuel sys-
tem.
To stop the flow of
fuel while replacing the
filter, it will be necessary
to carefully clamp the
fuel line between the
fuel tank and the filter.