17
Charging
WARNING: Charge battery in a well
ventilated area and keep away from an open
flame or pilot light as on a water heater,
space heater, furnace, clothes dryer or
other gas appliances.
If the vehicle has not been put into use for an extended
period of time, charge the battery with an automotive type
12-volt charger for a minimum of one hour at six amps.
Replacing Headlight Bulbs
1. Raise hood to get access to the headlight assembly.
2. Turn the bulb/socket assembly approximately a
quarter turn counterclockwise to align its tabs with
the notches of the reflector, then remove from the
reflector. See Figure 6.
3. Unplug the wire harness from the bulb/socket
assembly.
4. Plug the new bulb/socket assembly into the wire
harness.
5. Align the tabs of the new bulb/socket assembly with
the notches of the reflector and insert the bulb. Turn
the bulb/socket assembly clockwise to lock in place.
6. Lower and secure hood.
Fuses
1. Unlatch and lift hood forward to get access to under
the dash panel.
2. Remove fuse holder cover. See Figure 7.
3. Remove the appropriate electrical fuse and replace
with proper amperage fuse.
4. Lower and secure hood.
Tire Pressure
WARNING: Explosive separation of tire
and rim parts is possible when they are
serviced incorrectly. Do not stand in front
or over tire assembly when inflating.
The recommended operating tire pressure is ap-
proximately 14-18 psi for all tires. Overinflating above
recommended tire pressure can reduce the life of the tire.
Check tire pressure before driving the vehicle.
Wheel Replacement
WARNING: Using an unstable lifting
device and vehicle support may result in
bodily injury. Use a safe lifting device and
supports to work on raised vehicle.
1. Stop the vehicle on a level surface and apply parking
brake.
2. Turn the ignition key to the STOP position and
remove the key.
5
WARNING
Figure 6
Figure 7
Servicing
Your
Utility
Vehicle
Charge battery in a
well ventilated area
and keep away from
an open flame or
pilot light as on a
water heater, space
heater, furnace, clothes
dryer or other gas
appliances.
Explosive separation
of tire and rim parts is
possible when they are
serviced incorrectly.
Do not stand in front
or over tire assembly
when inflating.
Using an unstable lifting
device and vehicle sup-
port may result in bodily
injury. Use a safe lifting
device and supports to
work on raised vehicle.
Содержание J466
Страница 28: ...28 NOTES...
Страница 29: ...29 NOTES...