Cub Cadet 769-11722F, Руководство пользователя

Страница: 22 / 46

22
Removing/installing and adjusting the cutter deck
EN
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Î
Start the lawn tractor.
Î
Switch the parking brake on.
Î
Disconnect the jump leads in reverse sequence.
Tyre pressure
WARNING!
Increased tyre pressure
Â
Risk of accident and damage to the device
¾
Never exceed the permitted tyre
pressure (see tyre wall).
Î
Check the tyre pressure and correct it where necessary.
front: 0.9 bar
rear: 0.7 bar
Note
Excessive tyre pressure reduces the service
life of the tyres. Check tyre pressure prior to
each journey.
After 5 operating hours
Î
Perform the first engine oil change (for intervals
refer to the engine manual).
Î
Use the quick oil drain (optional) to drain the oil
V
.
Note
When draining the oil, use a suitable collec-
tion container.
Every 25 operating hours
Î
Lubricate all pivot points and bearing points of the
accelerator and brake pedals, of the cutting height
adjustment lever and of the PTO lever with a few
drops of light oil.
Î
Clean the battery terminals.
Î
Lubricate all blade shafts, tensioning pulleys and
tensioning pulley holders via the grease nipples
using grease type 251H EP.
Note
Arrange for this work to be carried out by a
service centre.
Î
Lubricate the wheel bearings and front wheel
axles at the lubricating nozzles using a multi-pur-
pose grease.
Î
Lubricate the wheels of the cutter deck at the
lubricating nozzles with a multi-purpose grease.
Î
Have the dirt and grass residue beneath the V-belt
cover of the cutter deck removed by a service
centre.
Every 50 operating hours
Î
Dirt and grass remnants must be removed from
the drive gear by a service centre.
Î
Have drive V-belts, blade shafts and tensioning
pulleys checked for wear and damage by a ser-
vice centre.
If required
Charge the battery:
Î
If you are not using the battery for lengthy periods,
remove the battery from the device.
Î
Charge up the battery every 6–8 weeks, as well
as before putting back into operation after storage.
Note
Follow the instructions in the operating man-
ual for your battery charger.
Replace fuses:
Î
Replace defective fuses only with ones of an
equal rating.
Note
The fuse is located on the red cable below
the driver's seat.
Once a season
Î
Clean the spark plugs and set the electrode gap
or replace the spark plug (see engine manual).
Î
The rear axles must be lubricated with a special-pur-
pose, water-repellent grease by a service centre.
Î
Have the cutter deck repaired only by a service centre.
Removing/installing and adjusting the cut -
ter deck
WARNING!
Risk of injuries or material damage
¾
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
¾
Remove the ignition key and the spark-
plug connectors.
¾
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾
Never reach into the rotating cutter blades.
¾
Wear protective gloves.
¾
Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.